WARNING
LED
Exit Signs
MODEL
OE-
316
PLEASE READ INSTRUCTION BEFORE COMMENCING INSTALLATION AND RETAIN FOR FUTURE REFERENCES.
Electrical products can cause death or injury, or damage to property.
If in any doubt about the installation or
use of this product, consult a competent electrician.
WARNING — THE INSTALLATION MUST BE CARRIED OUT BY
A QUALIFIED
ELECTRICIAN.
1.
LED
Exit Signs
are suitable for
indoor use only
. DO NOT use outdoors
2.
Please keep the LED
Exit Signs
a
way
from any corrosive substance
3.
LED
Exit Signs
can only be installed by a qualified electrician
4.
Before installation or maintenance, please disconnect the power
at fuse or circuit breaker
to
prevent electric shock
Instruction Manual
1-888-543-6473
1-888-541-6474
13376 Comber Way
Surrey BC V3W 5V9
[email protected]
www.ortechindustries.com
375 Admiral Blvd
Missis
s
auga
,
ON L5T 2N1
CAUTION
Application Notice
1. All electrical connections must be in accordance with local codes, ordinances and the National Electric code
2. DO NOT mount in hazardous locations, or near gas or electric heaters
3. DO NOT let power cords touch hot surface
4. Equipment should be mounted in locations and at heights where it will not be subjected to tampering by unauthorized personnel
5. The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition
6. DO NOT use LED Exit Signs for other than intended use
7. Allow battery to charge for 24 hours before first use
INSTALLATION GUIDE
AC Wiring
1. Connect the WHITE wire to NEUTRAL
2. If using 120V, connect the BLACK wire to the hot lead
3. If using 347V, connect the RED wire to the hot lead
4. Cap the unused lead
LED Strip
LED/SW
JK2 RH1
LAMP
2
LAMP1
MAIN
PCBA
TRAN
Batt2
Batt1
AC Input
Red 347V AC
Black 120V AC
White NEUTRAL
2nd Battery
1st Battery
Assembly Lamp Heads
1. Open front cover by flat screwdriver
2. Insert the lamp heads at the corners of main frame.
Select direction of lamp head before inserting
3. Connect male connector on lamp head to female
connector on PCBA
Connect lamp heads
connector on PCBA
Lamp head (forward)
Lamp head (backward)
Wiring Diagram
