INSTALLATION GUIDE
LED
Exit Signs
MODEL
OE-
316
Mounting Instruction
The fixture is suitable for wall mounting, side mounting, ceiling mounting.
1.
Open front cover
and assemble 2 pcs lamp heads on the frame
2. Knockout appropriate mount screw hole and cable hole, mount back
plate on the wall after feed building AC supply cable in to back plate
(see Fig.1 below)
3. For ceiling and side mounting purpose, remove the mounting hole
cover on the top or side of the unit, assemble the canopy
(see Fig.2,3,4 below)
4. Attach crossbar to junction box, set the longer blade of crossbar
touching the J-Box
5. Route the proper wires through mounting hole out of housing
6. Make electrical connections inside the J-Box like the wiring diagram on
page 1 of this instruction manual
7. Push excess wire into J-Box, use screws to tighten canopy to crossbar so
that copy is securely fastened and tight against the wall
8. Attach battery connector to PC board, restore front cover on unit, adjust
position of lamp heads as needed
9. If pictogram direction is assembled not suitable, pictogram can take out
for change direction or replace pictogram, and then insert into the
diffuser easily (see Fig.5 below)
Instruction Manual
1-888-543-6473
1-888-541-6474
13376 Comber Way
Surrey BC V3W 5V9
[email protected]
www.ortechindustries.com
375 Admiral Blvd
Missis
s
auga
,
ON L5T 2N1
Wall Mounting
Fig.1
Battery
Connector
J-Box
Side
Mounting
Fig.
2
Canopy
Crossbar
J-Box
Ceiling Mounting
Fig.3
J-Box
Crossbar
Canopy
Canopy Assembly
Fig.4
Insert canopy into housing at 20° and twist.
Quick snap is now locked firmly.
CAUTION: Trying to remove when canopy is locked in
place may cause damage.
Change Direction of the Pictogram
Fig.
5
Pictogram
