17
PICTURE CONTROL ADJUSTMENTS
The picture settings have been factory
adjusted under optimum signal recep-
tion. However, conditions may not be
the same in your area. After tuning in the
unit, allow it to warm up for a few min-
utes. If the picture is not to your liking,
make the following adjustments using
the remote control.
1
To adjust the picture, press
MENU
.
Press
▲
or
▼
to select the TV
SETUP mode, then press
ENTER
.
Press
▲
or
▼
to select the
PICTURE mode, then press
ENTER
.
2
Press
ENTER
until your desired
PICTURE mode appears e.g.
brightness, contrast, colour,
sharpness. Then press or to
adjust the level of the PICTURE.
(See below for details.)
3
After finishing the adjustment, press
MENU
3 times to
return to normal TV screen.
4
NOTE:
To resume the normal picture adjust-
ment, press
CANCEL
, while in the
picture mode menu.
Preparation
Press
TV/VCR
to select TV/VCR mode.
TIMER REC SET
AUTO REPEAT
OFF
CHANNEL SETUP
TV SETUP
SYSTEM SETUP
EXIT
ENTER
SELECT
: MENU
: ENTER
:
NEXT
RESET
SET
: ENTER
EXIT : MENU
: CANCEL
:
BRIGHTNESS
0
Each time you press
ENTER
the picture adjustment Screen
changes as follows.
BRIGHTNESS
Press
ENTER
until “BRIGHTNESS” appears on the screen, then
press or to adjust the brightness. When is pressed, the
darker portions of the picture become lighter.
SHARPNESS
Press
ENTER
until “SHARPNESS” appears on the screen, then
press or to adjust the sharpness.
In weak reception areas, the picture may be more pleasing when
the SHARPNESS is set at a lower level.
NOTES:
•
The picture settings can only be adjusted by using or
and
ENTER
when they are displayed on the screen.
•
Press
MENU
3 times to return to normal TV screen.
•
The On-screen display will disappear about one minute
after finishing an adjustment.
CONTRAST
Press
ENTER
until “CONTRAST” appears on the screen, then
press or to adjust the contrast. Pressing improves the
contrast and enhances the colour. Picture looks sharper in the
daytime by increasing the contrast level and sharper at night by
lowering the contrast level.
COLOUR
Press
ENTER
until “COLOUR” appears on the screen, then press
or to adjust the intensity of the colours. This should be set to
where the colours appear normal in intensity and brilliance.
ON/OFF TIMER SET
PICTURE
NICAM
TV SETUP
EXIT
ENTER
SELECT
: MENU
: ENTER
:
AUTO
