6(22)
Reel:SETUP ‡
EXIT STOP CE ENT
PASS:_
‡
Enter Password
Addr:8???_
‡
Address[CODE]
TCM:
‡
TCM MainMenu
TCM: ‡
TCM MainMenu
Address:8XXX ‡
Ange Adress 8???
Address:8XXX ‡
Set Address 8???
4. Configuration
An
OriLink
®
configuration sheet
should
always be filled or altered during the configuration.
NOTE! To obtain technical support a copy of the configuration sheet for the complete installation must be
sent to Alentec & Orion AB at
Alentec & Orion AB
TECHNICAL SUPPORT
Grustagsvägen 4
SE-138 40 ÄLTA
SWEDEN
or
[email protected].
4.1. Check before configuration
Check that the TSM is working and communicating with the system according to the OriLink
®
Manual
chapter
Testing modules
.
NOTE!
Do not forget to check and adjust the termination and BIAS according to OriLink® Manual.
4.2. Addressing the TSM
A new module has a default address when delivered such as MPDM 1000, PM 2000, KP 3000, LED 4000, TSM
8000 and so on. To set an address for a new TSM or a TSM with unknown address press and hold its RESET button
for 5 seconds to set a temporary address. Immediately enter set-up mode from a KP and type 0 and then ENTER to
get to the Main menu of the TSM, see below.
NOTE!
Only one new module can be installed at a time. If you press the RESET-button on several
terminals simultaneously or in a sequence, only the most recently pressed will be active.
TIP!
Follow preferably”Recommendation for setting new addresses” when setting addresses.
4.3. Set-Up mode
Type the word
”SETUP”
on a KeyPad and press
ENTER
.
Type the
password
and press
ENTER
.
Type the address
for the TSM that is to be configured and press
ENTER
to access
its main menu. It is possible to add the 4-digit menu code to go directly to the
desired menu.
Scroll
through the TSM sub menus by pressing
or
. When the desired menu is
shown press ENTER etc. On display it shows TCM because the TSM and TSM
share the same software.
4.4. Change address
[TCM//Address]
Enter menu
[TCM//Address]
by pressing
ENTER
.
Press
ENTER
to get the cursor.
Type in the
desired address
and acknowledge by pressing
ENTER
. When the
cursor disappears it is finished.
Press
EXIT
two times to leave Set-Up mode.
NOTE! If two or more TSM’s have the same address the system will fail. The TSM’s has to be re-addressed.
Hint!
Follow preferably ”Recommendation for setting addresses” when setting addresses.
Summary of Contents for OriLink 23430
Page 15: ...15 22 6 Menu tree...
