3(22)
1. Introduction
The OriLink® TSM module, (
T
ank
Surveillance M
odule), is used to control pumps and/or measure levels in tanks
using floater based level switches. A TSM can be used both for fresh and waste oil tanks.
The TSM (23430) is based on a TCM 23408 but has a lid (p/n 203 03 11) with a led indicator board (p/n 203 03 03)
and a connector adapter (p/n 203 03 17) added to the main board 203 02 91.
Earlier models than serial number 12-02000 can be made with either a MPDM (23400) with another software ( chip
labeled TSM 1.xx.xx) and/or have a lid with chassis mounted indicator led’s. Because of this a lot of this manual also
in most parts covers older modules. Some features may be missing and some default settings may be different.
NOTE!
The OriLink® installation manual should be available when installing and configuring a TSM.
2. Mechanical installation
The TSM is delivered mounted in a metal box with power supply. It can also be delivered as a spare part PCB (p/n 203
03 91) .
Complete TSM in a box is mounted on a wall or other suitable place using the four-ø5 mm holes in the bottom corners
of the box.
If a PCB is used it is important that a power supply with enough performance is used, 24VBC 5A.
3. Electric installation
3.1. The main module
The TSM should be connected to mains 230VAC/50Hz using phase, neutral and ground.
Alentec & Orion AB recommend that the connection is done through a 2-pole lockable working switch.
The “knock-out” holes on the lower right hand (see picture) should only be used for mains power supply to separate
mains from the circuit board (DC) side of the module.
The TSM is equipped with a switched power supply of 150W that can be set for 110VAC/60Hz or 230VAC/50Hz
by the internal switch shown by the yellow sticker.
It has five connectors
(A)
for the OriLink® communication. Two of these connectors,
MPDM IN
and
MPDM
OUT
are not connected to
+24V
and are intended for a connection to another TSM, MPDM or other modules that
already have +24VDC. This is to prevent conn24VDC from two power supplies.
The other three connectors are used to connect external devices without a power source such as a Printer Module
(PM), a LED Module (LED) and/or a KeyPad (KP). These connectors can only supply power to a single device. For
more detailed information see the
OriLink® Manual
Summary of Contents for OriLink 23430
Page 15: ...15 22 6 Menu tree...
