Orion OriLink 23408, Manual

Page: 2 / 21

2(21)
Table of Contents
1. INTRODUCTION 3
2. MECHANICAL INSTALLATION 3
3. ELECTRIC INSTALLATION 3
4. CONFIGURATION 5
4.1. C
HECK BEFORE CONFIGURATION
5
4.2. A
DDRESSING THE
TCM 5
4.3. S
ET
-U
P MODE
5
4.4. C
HANGE ADDRESS
[TCM//A
DDRESS
] 5
4.5. R
ECOMMENDATION FOR SETTING ADDRESSES
5
5. CONFIGURE THE PORTS 6
5.1. C
ONNECT A TANK TO A PORT
[TCM//P
ORT
X/T
ANK
] 6
5.2. S
ET THE
M
ASK
[TCM//P
ORT
X/M
ASK
] 6
5.3. A
NALOGUE SENSOR SETTINGS
7
5.3.1. Set the input signal filter time constant ............................................................................................. 7
5.3.2. Adjusting the offset ............................................................................................................................ 7
5.3.3. Adjusting the calibration ................................................................................................................... 7
5.3.4. Set sensor full scale ........................................................................................................................... 8
5.4. F
LUID SPECIFICATION
9
5.4.1. Set fluid name .................................................................................................................................... 9
5.4.2. Set fluid part number ......................................................................................................................... 9
5.4.3. Set the fluid density ........................................................................................................................... 9
5.5. T
ANK SPECIFICATION
10
5.5.1. Set tank capacity .............................................................................................................................. 10
5.5.2. Set the tank reorder volume level .................................................................................................... 10
5.5.1. Set the tank stop volume level .......................................................................................................... 10
5.5.2. Set tank bottom area ........................................................................................................................ 11
5.5.3. To configure a TCM port for a tank that does not have a constant area ........................................ 11
5.6. D
ISPLAYING TANK CONTENT ON A
LED
DISPLAY
12
5.6.1. Set LED address .............................................................................................................................. 12
5.6.2. Set LED update interval .................................................................................................................. 12
5.7. S
ET THE TYPE OF TANK
(PC
SYSTEM
). 13
6. MENU TREE 14
7. FAST MENU CODES 15
8. TECHNICAL SPECIFICATION 16
9. TO CONNECT DISCRETE LEVEL SENSORS 23 132/138/171 AND SOLENOID VALVES 17
9.1. F
RESH OIL TANK
, 23138 (2-
LEVELS
) 17
9.2. F
RESH OIL TANK
, 23171/23183 (1-
LEVEL
) 17
9.3. W
ASTE OIL TANK
, 23132 (2-
LEVELS
) 17
9.4. O
NE
TCM
PORT CONTROLS A NUMBER OF PUMPS
18
10. EX-BARRIER 23187 FOR DISCRETE LEVEL SENSORS. 18
10.1. C
ONNECTING A WASTE OIL TANK
23132 (2-L
EVELS
) 19
11. TO CONNECT AN ANALOGUE SENSOR 19
11.1. A
NALOGUE SENSOR
23417 19
11.2. C
ONNECTING AN ANALOGUE SENSOR
. 20
12. EX-BARRIER 23 188 FOR ANALOGUE SENSORS. 20
12.1. C
ONNECTION
21
13. MPDM PCB MOUNTED IN A TCM BOX 21