4
WIRELESS AUTODIAL
HOME ALARM SYSTEM
AM2000
PROFESSIONAL
SECURITY SYSTEM
Press and hold
Record Button
for 3 seconds
to record 10 seconds voice message. Or send
SMS to system for calling back to record the
voice messages (Refer to section 2.13). The
Play Voice Memo Button
will be flashing in
blue to remind you. Users can touch the center
of circle to listen to the voice memo. The LED
indicator blacks out when the voice is played.
Replay by
touching
it again.
The RFID tag is for disarming the system and
unlocking the electronic door lock (if connected).
You can rename the RFID tags and store a
mobile phone number to send SMS notice
when family members come home and disarm
the system (Refer to section 2.19 and 2.24).
NOTE:
1. Only after SMS No. is stored and the RFID tags SMS
notice is changed (4 RFID tags can be renamed), users
can receive notice SMS once someone disarms the
system by RFID tag.
2. RFID tags only operate when AM2000 alarm panel is
powered by power supply.
2.3
RECORD/PLAY VOICE MEMO
2.4 RFID TAG
2.5 SPEED DIAL
1. Enter alarm panel password (Default:1234).
2.
Press
Connect Button
and button
illuminates.
3.
Trigger signal within 15 seconds after
pressing
Connect Button
.
a. AM2010 PIR Motion Sensor: Press test
button twice.
b. AM2020 Door/Window Contact Sensor:
Break contact by moving magnet away
from sensor.
c. Remote Control: Press any button on the
remote control.
d. RFID Tag: Wave RFID tag near alarm
panel RFID reader.
4.
Connection successful when alarm panel
beeps once.
NOTE:
• If alarm panel beeps twice, accessory has
been added before.
• Alarm panel assigns zones sequentially.
The first connected accessory is assigned in
Zone 1, the second one in Zone 2 and
so on.
• Alarm panel supports up to 10 remote
controls, 50 wireless sensors or sirens and
50 RFID tags.
2.2 CONNECT WIRELESS STROBE SIREN
2.1
CONNECT WIRELESS SENSORS,
REMOTE CONTROLS & RFID TAGS
AM2030 Strobe Siren can be added to
increase alarm visibility and audibility.
1. Open AM2030 siren front cover.
2.
Press and hold tamper switch for the entire
pairing setup to avoid false tamper alarm.
3. Connect power supply to AM2030 siren.
4.
Disarm AM2000 control panel by keying in
password and pressing
Disarm Button
.
5.
Press and hold AM2030 siren
Pairing
Button
for 0.5 second.
6.
Arm AM2000 control panel by pressing
Arm Button
to pair with AM2030 siren.
7.
When AM2030 siren beeps once, they are
paired successfully.
8.
After pairing, disconnect power supply and
reassemble front cover.
9.
AM2030 siren is ready for use and fixed
mounting installation.
When intruder is detected, both AM2000
control panel and AM2030 strobe light siren
will hoot to deter the intruder. The siren will
turn off in 1 minute on factory default setting.
Press
Call Button
, the panel auto dials
to pre-stored phone number of the host.
Press
Call Button
again to end phone call
(Refer to section 2.20).
