Orion AM2000, Instructions For Use Manual

Page: 14 / 16

14
WIRELESS AUTODIAL
HOME ALARM SYSTEM
AM2000
PROFESSIONAL
SECURITY SYSTEM
LED INDICATOR
MAGNET SENSOR
5
WIRELESS MOTION SENSOR
TAMPER SWITCH – when the case
is opened during armed state, the
tamper switch will be triggered
and generate a signal to alarm the
AM2000 control panel.
TAMPER SWITCH
ZONE SETUP
1.
Slide open the rear case and remove
battery insulation strip.
2. Mount the sensor on the door frame
and the magnet on the door.
3. Ensure the magnet is on the right side of
the sensor where the arrow is located.
4.
Place the sensor in the desired location;
mount the magnet no more than 10mm
away from the sensor and secure the
sensor and magnet with double sided
tapes (supplied) or screws (not supplied).
5. Avoid mounting sensors in areas with large
quantity of metal or electrical wiring, such
as full metal frame and door, furnace or
utility room.
Pairing with AM2000 control panel
Key in the password and press the connect
key on AM2000 control panel, then trigger
the sensor by opening the door it is mounted
on. When one beep sound from the AM2000
control panel is heard, they are paired.
To check if they are connected successfully, arm
the AM2000 control panel, trigger the sensor
unit by opening the door it is mounted on; if
there is an alarm, the connection is successful.
5.1
INSTALLATION AND NOTICES
5.2
INTERNAL AND FUNCTIONS
5.3
OPERATION
IMPORTANT –
When the zone setting is changed, the
sensor must re-pair with am2000 control panel.
HOME MODE
ZONE
NORMAL
ZONE
SINGLE DELAY
ZONE
ZONE SETTING – set the jumpers to
different zone mode for different alarm
activation method.
HOME MODE ZONE
– when home mode
button is pressed on AM2000 control panel
or the remote control, it will not trigger the
alarm, and therefore occupants can move
freely inside the room. Meanwhile other zone
setting will remain armed.
NORMAL ZONE
– when AM2000 is armed,
if intruder detected, it will trigger alarm
immediately.
SINGLE DELAY ZONE
– when AM2000 is
armed, if intruder detected, it will trigger alarm
after 30 seconds time delay in default settings.
NOTE:
AM2020 wireless door/window contact
sensor is set to “SINGLE DELAY ZONE”
by default.