RES-P3242GCL SERIES User’s Manual
18
The following table describes the labels in this screen.
Label
Description
Enable Ring
Mark to enable Ring.
Enable Ring Master
There should be one and only one Ring Master in a ring.
However if there are two or more switches which set Ring
Master to enable, the switch with the lowest MAC address will
be the actual Ring Master and others will be Backup Masters.
1
st
Ring Port
The primary port, when this switch is Ring Master.
2
nd
Ring Port
The backup port, when this switch is Ring Master.
Enable Coupling Ring
Mark to enable Coupling Ring. Coupling Ring can be used to
divide a big ring into two smaller rings to avoid effecting all
switches when network topology change. It is a good
application for connecting two Rings.
Coupling Port
Link to Coupling Port of the switch in another ring
.
Coupling
Ring need four switch to build an active and a backup link.
Set a port as coupling port. The coupled four ports of four
switches will be run at active/backup mode.
Control Port
Link to Control Port of the switch in the same ring. Control
Port used to transmit control signals.
Enable Dual Homing
Mark to enable Dual Homing. By selecting Dual Homing
mode, O-Ring will be connected to normal switches through
two RSTP links (ex: backbone Switch). The two links work as
active/backup mode, and connect each O-Ring to the normal
switches in RSTP mode.
Apply
Click “Apply” to set the configurations.
Note:
We don’t suggest you to set one switch as a Ring Master and a Coupling Ring at the same time due to heavy
load.
4.1.4.2 OPEN-Ring
Open-Ring technology can be applied for other vendor’s proprietary ring. Thus, you can
add switches of ORing into the network constructed by other ring technology and enable
Open-Ring to co-operate with other vendor’s managed switch.