12
ANSI
-
Declaration of conformity
3553/3558
-
03
-
208/230, 3553/3558
-
03
-
460, 3553/3558
-
03
-
575/600, 3554/3559
-
03
-
208/230, 3554/3559
-
03
-
460,
3554/3559
-
03
-
575
Original Saw declares that these power tools have been de-
signed in compliance with ANSI Machine Standards 01.1
-
2013.
For more information, please contact Original Saw at the
address below or refer to the address on back of the manual.
Noise Exposure
•
It is the responsibility of the installer and end user to
ensure The Noise Exposure requirements of 29 CFR
1910.95 are satisfied.
3553/3558
-
03
-
208/230, 3553/3558
-
03
-
460, 3553/3558
-
03
-
575/600, 3554/3559
-
03
-
208/230, 3554/3559
-
03
-
460,
3554/3559
-
03
-
575
LpA (sound pressure) dB(A)* 85.5 85.5
LWA (acoustic power) dB(A) 93.5 93.5
* at the operator
’
s ear
Take appropriate measures for the protection of hearing if
the sound pressure of 85 dB(A) is exceeded.
Original Saw Company
465 Third Ave SE
Britt, IA 50423
PH 641
-
843
-
3868 FX 641
-
843
-
3869
e
-
mail: [email protected]
Intended Use of Machine
•
Machines for Wood and plastic cutting only
•
Maximum size of material
•
3553/ 3558 width 23 /
31”
depth
6.25”
•
3554/ 3559 width 23 /
31”
depth
8”
Residual Risks
The following risks are inherent to the use of radial arm
saws:
In spite of the application of the relevant safety regulations
and the implementation of safety devices, certain residual
risks cannot be avoided.
These are
:
•
Impairment of hearing.
•
Risk of accidents caused by contact with the uncov-
ered parts of the rotating saw blade.
•
Risk of injury when changing the blade.
•
Risk of pinch hazard between base and carriage of
machine.
•
Health hazards caused by breathing dust developed
when sawing wood, especially oak, beech, MDF.
Dust / Chip Collection
End user must ensure that the machine is installed in a
well ventilated area with chip and dust extraction system
fitted to the extraction points
•
The machine is set for indoor use only and must be
connected to a dust/chip collection system.
•
The dust collection system must be switched on be-
fore cutting operations can begin.
•
The hoses on the dust collection must be grounded to
PE
•
There are dust collection shrouds available as acces-
sories please call customer service at 641
-
843
-
3868
or email [email protected] with any
questions
Eye Protection
•
Eye protection must be worn at all times during use.
Trip / Slip Hazard
•
Make sure power cable is routed in a manner to en-
sure there is no trip / fall or a slip hazard
•
Keep work area around saw clean and free of
hazards.
Blades
•
Use only blades that are rated at the specified 3600
RPM when machine is operate at 60Hz or 2825 when
machine is operated on 50 Hz the RPM on the ma-
chine guard no blade shall be used that is not rated for
the rpm of the machine.
Lighting requirements
•
The area around the machine must be well lit.
ANSI Conformance
Summary of Contents for 3553
Page 34: ...34 Intentionally left blank ...
