12
Mode DIP Switch
Mode DIP Switch
Located on the rear panel, the MODE DIP switch controls the following settings.
1 DRY/BYPASS DIP SWITCH:
This switch is only active when the REAMP switch is set to the PWR AMP
position. With PWR AMP selected, the DRY/BYPASS DIP switch modifies the BYPASS and DRY signal
path to incorporate the pedal’s PREAMP circuitry.
In bypass, with switch 1 in the downward position, the signal present at the input connector is routed to the
pedal’s output via a high-quality buffer. With the pedal engaged, any blended DRY component is fed from
the same buffer. Use this setting when plugging into a guitar amp.
When plugging into a flat-response power amp, move the switch to the upward position. When the pedal is
bypassed, the input signal now passes through the preamp filter stage, controlled by the PREAMP switch
on the currently active channel. This means you can still take advantage of the RevivalDRIVE Hot Rod’s
classic amp-style tone shaping, even when not using the main overdrive circuit. The pedal’s two channels
remain switchable even in BYPASS mode, allowing you to set up two distinct tones.
2 RECTIFER DIP SWITCH:
Move switch 2 to the up position to transform the VALVE RECTIFIER channel
into a second SILICON RECTIFIER channel.
3 GHOSTING DIP SWITCH:
Switch 3 toggles between 50Hz/British (switch down) and 60Hz/USA (switch
up) simulated mains frequencies, subtly altering the pitch of the ghost tones generated.
ON
1 2 3
Summary of Contents for REVIVALDRIVE HOT ROD EDITION
Page 1: ...OWNER S MANUAL Version 1 0 ...
Page 20: ......
