6
Suggested Connection Settings
Suggested Connection Settings
Plugging into a guitar amp, bass amp or amp modeller
RE-AMP EQ:
Select EQ1 (for brighter sounding
amps) or EQ2 (for darker sounding amps) on the
RE-AMP EQ switch. Use the HI SHELF boost/cut
control and BRI-CAP CUT filter to adjust for the high-
frequency response of your amp.
Note that in the case of the “Custom” model,
switching to the EQ2 setting enables the custom
panel controls, which offer compatibility with bright
and dark amps alike. Please see
Controls: “RevivalDRIVE Hot Rod CUSTOM” on
for more information.
Plugging into a flat-response power amp, recording interface or mixer DI
RE-AMP EQ:
Select PWR AMP on the RE-AMP EQ switch and use the HI SHELF boost/cut control to
fine-tune the high-frequency response. Set the BRI-CAP CUT filter control fully counter-clockwise (no treble
roll-off).
MODE DIP switch:
On the rear of the pedal, set switch 1 on the MODE DIP switch to the upward position.
When the RevivalDRIVE Hot Rod is in BYPASS mode, your input signal will still pass through the preamp
EQ filters.
Please note that a cabinet simulator will be required for DI applications where the signal is to be reproduced
via a full-range speaker system.
ON
1 2 3
Cabinet simulation
device or software
ON
1 2 3
Summary of Contents for REVIVALDRIVE HOT ROD EDITION
Page 1: ...OWNER S MANUAL Version 1 0 ...
Page 20: ......
