SPECIFICATIONS (CONT.)
LED Indicators
Power, Ready, Timing, Alarm
Method of Cooling
Convection
Ambient Temperature
Range
32° - 104°F (0° - 40°C)
Weight
1.8Ib (0.8kg)
Outer Dimensions
1.4"(W) x 9.5"(H) x 4"(D) [35mm(W) x240mm(H) x 100mm (D)]
Dielectric Strength
Sufficient to withstand 1 KVAC applied for 1 minute, between the input
power terminal and the case .
Insulation Resistance
Greater than 100Mohms when measured between the input power
terminal and the case by a 500 VDC megger.
Motion Data Settings
Operating
Modes:
Index Mode: Move a preset number of steps.
Return-to-Electric Home Mode: (Returns to point where internal
counter is 0) Maximum number of steps from
home = ±16,777,216 steps.
Jog Mode Move 1 step per "Start " signal, or move 4pps with a
continuous "Start" signal.
Continuous Running/Home Hunting Mode: Runs continuously until
told to stop or seeks out a mechanical home
limit switch when used with an external
controller.
Number of Index Steps
Decimal; 4 digit; 0 - 9,999 steps (PULSE)
Speed Range
2 Ranges; Low (1000pps max) and High (5000pps max) (RANGE)
Pulse Speed
Running Speed; 16 levels (0 - F) for each speed range,
32 total (SPEED)
AcceVDecel
Rate
Acceleration/Deceleration Rate; 4 (0 - 3) for each speed range,
8 total (RATE)
SW Control
Disables CW/CCW, RESET, S-STOP and START switches on the
DP-01when in the "OFF" position. This allows these functions to be
controlled exclusively from an external controller. (SW CONTROL)
Direction
Two directions; CW and CCW (CW/CCW)
Pushbuttons
RESET; Stops the motion and resets the internal counter to zero.
(RESET)
S-STOP; In the continuous mode, the motor will slow down to the
appropriate base speed (50pps in the Low range, 300pps in the High
range). In the Index and Return modes, the motor will decelerate and
stop. The interrupted move will be completed when the next "START"
signal is received. (S-STOP)
START; T h e "START" signal causes the UI215GA to read all of the
input data lines, calculate the motion profile and then begin the
motion. All input switches are ignored (except for S-STOP and
RESET) until the move has been completed and the READY light
turns "ON".
Weight
0.661b (0.3kg)
Ambient Temperature
Range
32° to 104°F (0° to 40°C)
Outer Dimensions
0.79"(W) x 9.45"(H) x 3.49"(D) [20mm x(W) x 240mm(H) x 100mm(D)]
INTELLIGENT DRIVER UI215GA (CONT.):
DATA PACK DP-01:
41