OREC RM60W
10
INSPECTION BEFORE USE
Before each use of machine, refer to table below and realize the inspection.
LIST OF PRE-USE INSPECTION
Where to check
Check point
Engine
Engine oil
Quantity and dirt of oil
Air cleaner
Dirt
Machine
Blade
(1) Looseness or loss of bolt
(2) Deformation, wear or contact
(3) Smooth movement or sticking
(4) Remove dust and grass
Brake(if equiped)
Tire
Lever(s)
Cover(s)
HST oil(if equipped)
Quantity and dirt of oil
WARNING
1)
Always make inspection, re-fueling, adjustment and maintenance only after engine is stopped. ]
2)
Make sure about position of each lever and safety around the machine, before to start engine and
check the movement of levers.
3)
Check and read the safety labels on the machine.
ENGINE OIL INSPECTION
1)
Place the machine on flat
surface and remove the oil gauge.
2)
Edge of oil cap is designed
as oil gauge. Wipe the oil gauge with
cloth and insert it to check the oil level.
If oil level is not between upper and
lower limit, add engine oil until the
level comes between upper and
lower limit.
CAUTION
1)
In case of checking engine oil after the work, wait more than 5 minutes to cool down the engine. Make sure
if muffler and engine is cooled enough.
2)
Shortage of excess of engine oil cause engine trouble. Check the engine oil before every use.
3)
Recommended engine oil type is 10W-30.
4)
After the engine oil is filled up, securely fix the oil gauge. If the fixing is loose, engine oil may leak.
FUEL INSPECTION AND REFUELLING
1)
Place the machine on flat surface and remove fuel cap. Check
the level of fuel through fuel mouth.
2)
In case fuel gauge is close to “E”, it is necessary to refuel.
Oil cap
Oil gauge
Lower limit
Upper limit
Fuel cap
Fuel gauge
