OREC RM60W
13
7) Insert the ingition key to engine switch, then turn the key from “I” position
to “
” to start engine.
8) When engine is started, leave hand from the key. Key automatically turns
back to “I” position.
9) After engine is started, push back the choke lever(to ) then move
the throttole lever to MINI to warm the engine for about 5 minutes.
WARNING
For your safety, make sure to keep parking brake pedal “locked” by brake
stopper, while warming the engine.
CAUTION
When starting the engine, do not keep ingnition key more than 5 seconds at “
” position because big amount of
electricity runs into cell motor.
If engine cannot be started within 5 seconds, turn the key to “O” and wait more than 10 seconds, then try again.
While engine is running, do not turn the key to “
” position. This may lead to trouble of cell motor. If engine is
warm enough, start the engine with throttle lever at intermediate position.
TIP :
Warming up the engine can circurate the oil inside the engine, and it is better for engine lifetime.
S
TOPPING THE ENGINE
1) Move the throttle lever to MINI.
2) After 2-3 seconds at MINI position, turn the key to “O” position to stop
engine.
3) Remove key from engine switch.
4) Close the fuel cock.
D
RIVING
1) Start the engine.
2) Move the throttle lever to MAX to increase the engine rpm.
3) Press the parking brake pedal to unlock the brake stopper. Do not change
speed while parking brake pedal is locked. Driving the machine with parking
brake locked will bring overload on brake and transmission and cause the
breakdown.
4) Slowly shift the speed control lever forward and start drving.
TIP :
Driving speed is adjusted following the tilt angle of speed control lever. For
your safety, start driving in low speed.
Engine switch
MAX
MINI
MINI
MAX
Parking brake pedal
Brake stopper
Unlock
