OPERATION
End of the Application
Turn off the machine by putting the on/off
switch to “O”. If a cleaning solution was used,
fill bottle cartridge with water and spray out
system for 30 seconds. Make sure to not let
solution come in contact with the motor.
Storage
To avoid damage to the handle frame, do
NOT lay machine frame on floor as done with
other traditional cleaning equipment. Remove
the pad from the driver plate by pulling it
down firmly. Put machine frame in an upright
position by pulling the black knob with the left
hand and move the handle frame upwards
with the right hand. The black knob should
lock firmly in the top hole.
CAUTION
To allow for easy transportation of the
machine, remove the weight kit if used. Use tie
down straps to secure the machine to the truck
or trailer during transport. It is recommended
to completely drain or remove the solution tank
prior to transporting.
To easily roll machine, push your foot on the
back wheel axle and pull handle towards you.
Moving machine similar to a dolly. Always
store with the base in the upright position.
Lifting and Carrying
Without a ramp, we recommend 2 people
to lift machine in and out of vehicle setting
wheels down first, then base. Lock handle in
a lower position. Make sure that the machine
base rests on a pad, so that the grip surface
of the driver plate does NOT get damaged or
hooked onto a carpeted surface.
WARNING
Grip the machine from each side as shown.
Do NOT grip too close to the machine base.
If the base should flip upwards it can cause
serious hand injury.
Lift machine with a back-friendly posture. And
then secure machine firmly so it will not move.
11
