SAFETY
7
GROUNDING INSTRUCTIONS 120V
THIS PRODUCT IS FOR COMMERCIAL USE ONLY
ELECTRICAL:
In USA this machine operates on a 15 amp nominal 120V, 60 hz, A.C.
power circuit. The amp, hertz, and voltage are listed on the data label found on each
machine. Using voltages above or below those indicated on the data label will cause
serious damage to the motors.
GROUNDING INSTRUCTIONS:
This appliance must be grounded. If it should
malfunction or break down, grounding provides a path of least resistance for electric
current to reduce the risk of electric shock. This appliance is equipped with a cord that has
an equipment-grounding conductor and grounding plug. The plug must be inserted into
an appropriate outlet that is properly installed and grounded in accordance with all local
codes and ordinances.
For use on a nominal 120 volt circuit with a grounded plug that looks like the plug in
FIGURE A. A temporary adaptor that looks like the adaptor in FIGURE C may be used to
connect this plug to a 2-pole receptacle as shown in FIGURE B, if a properly grounded
outlet is not available. The temporary adaptor should be used only until a properly
grounded outlet (FIGURE A) can be installed by a qualified electrician. The green colored
rigid ear, lug or similar that extends from the adaptor must be connected to a permanent
ground such as a properly grounded outlet box cover. Whenever the adaptor is used, it
must be held in place by a metal screw.
WARNING
Improper connection of the
equipment-grounding conductor
can result in electric shock. Check
with a qualified electrician or
service person if you are in doubt
as to whether the outlet is properly
grounded. Do not modify the plug
provided with the appliance - if it
will not fit the outlet, have a proper
outlet installed by a qualified
electrician.
EXTENSION CORDS:
It is recommended to only use the supplied power cord. However,
when the use of an extension cord is unavoidable, use only three-wire 12/3 or larger
gauge approved extension cords that have threeprong grounding type plugs and three-pole
receptacles that accept the machine’s plug. Replace or repair any damaged cords or plugs.
SAFETY LABEL LOCATION:
If at any time the safety labels become illegible, contact your
authorized representative for prompt replacement.
