24
Remark: After replacing lower controller and replacing the parts for E5/E6 issue, please follow steps below to
re-calibrate the machine
1.1 Press PROG and SPE+ KEY at the same time and POWER UP or reset SAFETY KEY entry. After entry, LCD will
run display testing, all segment will lights up to show according.
1.2 If press START KEY, the computer will take the default data to calibrate and save into EEPROM.
1.3 Press MODE to entry unit setting mode
1.4 Press MODE to entry the setting mode of WHEEL SIZE
1.5 Press MODE to entry the setting mode of MIN SPEED
1.6 Press MODE to entry the setting mode of MAX SPEED
1.7 Press MODE to entry the setting mode of MAX ELEVATION
1.8 Press START KEY to entry SPEED CALIBRATE, It
will show ―CAL‖ in the window of SPEED in sprinkle. After
calibrate will back to IDLE MODE automatically.
You can start to use your treadmill after the calibration test be done
Check incline motor sensor wire and AC wire are plugged into
lower control board correctly; match +/- with colored wires; test
continuity in connection wires; replace wire and/or incline motor to
test; finally, do the calibrate testing according to below steps.
E6
Anti-surge Protection
：
abnormal power supply or DC
motor dysfunction
E6 display on computer with 3 beeps, no display in other windows.
Machine can be switched OFF and ON again, when Start key is
pressed, E6 may appear again
Check input AC voltage if it’s below 200V and change to another
power outlet; check lower controller for burning smell or burnt
marks, change if necessary; check wire connection to DC motor,
re-plug and test motor; change DC motor if necessary.
E7
Computer reading EEPROM
error
Change upper EEPROM in computer
E8
Lower controller reading
EEPROM error
Change lower EEPROM in lower controller
