Appendix E: Preparing the ADE-BDE Cable
2
Ocean TRx™ 4500 Installation and Operations Manual
Preparing the Cable
Perform the following procedure to prepare the connectors on both sides of the
LMR cable.
1. Flush cut the cable squarely.
2. Slide the heat-shrink boot and crimp
ring onto the cable. Strip the cable
end using the ST-400-EZ prep/strip
tool by inserting the cable into End
1 and rotating the tool. Remove any
residual plastic from the center
conductor.
3. Insert the cable into End 2 of the
ST-400-EZ prep/strip tool and
rotate the tool to remove the plastic
jacket.
4. Debur the center conductor using
the DBT-01 deburring tool.