Orbit Fitness T6610N, Owner'S Manual

Page: 9 / 40

8
ASSEMBLY INSTRUCTIONS
FIG 1
STEP 13: Insert the SENSOR WIRE(29) and PULSE CONNECTION WIRE(75) into the bottom end of
METER POST(31) and pull them out of the top of the METER POST(31). Pull the
HANDLEBAR(25), twist the STRAP(21) and slide the strap thru the gap into the hole in the bottom
of the METER POST(31). Slide the METER POST(31) onto the MAIN FRAME(1) and secure with
SCREW(M5x18mm)(84).
STEP 14: Plug the SENSOR WIRE(29) and PULSE CONNECTION WIRE(75) to the METER(30) and push
the excess wires back into the METER POST(31). Attach the METER(30) onto the METER
POST(31) with two BOLT, BUTTON HEAD M5x0.8x12mm(115).
NOTE: Please be careful not to damage the SENSOR WIRE when attaching the METER(30).
STEP 15: Refer to FIG. 1 above. Turn counter clockwise the Adjustment Pad until it stands on the ground
completely to ensure the stability when using.
STEP 16:
a. A bottle of silicone is packed together with user’s manual.
b. Gently apply the silicone to the rollers sliding path
(inner upper side and inner bottom side) on the aluminum rail.
Note: Apply liberally but be cautious not to spill the lubricant as
applied surfaces will become very slippery. To clean spills use
warm soapy water, repeat if necessary.
c. Then slowly slide the Seat forward and backward for a few seconds
allowing the lubricant spread evenly on the rollers sliding path on
aluminum rail.
Adjustment Pad
Lubricate the silicone to
the rollers sliding path on
the aluminum rail.