Orbis CODITEL 2, User Manual

Page: 43 / 156

En
gli
sh
- 41 -
User Manual CODITEL 2
• Setting the text message forwarding to the sender (for admin only)
The instrument can be set to send the sender a text message of confirmation upon
receiving a command via a text message. The command is
OUTRISP
[status] with status that can assume the values:
− ON  enables the sending of a text message of reply to the sender
− OFF  disables the sending of a text message of reply to the sender
If the status is omitted, the reply will be the current instrument status.
• Setting display
The device can be queried to know the relevant configuration, using the command:
OUTINFO
Here is an example of a possible reply:
OUT 1=ON OUTRING= ON 5S OUT 2=OFF OUTRING=ON 2S OUTRISP=ON
RINGRISP=ON OUTKEY=RING
meaning:
output 1 on, response to a ring on for 5 seconds, output 2 off, response to a ring on for 2
seconds, reply to text messages enabled, reply to a ring enabled, reaction to pressing a
key the same as to a ring
• Modifying output names (for admin only)
To assign a name to the output that recalls the device to which it is connected, use the
command:
OUTTXT [output number] [output label]
Some examples:
OUTTXT 1 port
assigns output 1 the name port
OUTTXT 2 valve assigns output 2 the name valve
OUTTXT 2 NO restore the original name to output 2
A string of a maximum of 10 characters with no spaces can be assigned as
a name. To restore the original name, just write OUTTXT NO. If an alternative
number for an output is defined, it is possible to use this name to indicate the
output in the transmitted commands. For example:
valve ON 10 M activates output 2 (valve) for 10 minutes