Orban Optimod-TV 8382, Operating Manual

Page: 53 / 244

OPTIMOD-TV DIGITAL INSTALLATION
2-11
instructions on how to use them in this application. They are the preferred
choices because their AGCs are identical to the AGC in the 8382.

Discontinued Orban products usable as external AGCs include the 8200ST, 464A
“Co-Operator,” 8100AST, and 1100 OPTIMOD-PC. In this manual, we do not pro-
vide step-by-step instructions for setting up all of these older products, although
it should be easy to extrapolate from the instructions we do provide.
If you are using Orban 8200ST Studio Level Controller
If the STL uses pre-emphasis, its input pre-emphasis network will probably introduce
overshoots that will increase peak modulation without any increase in average
modulation. We therefore strongly recommend that the STL transmitter’s pre-
emphasis be defeated (freeing the STL from such potential overshoot), and that the
8200ST be used to provide the necessary pre-emphasis.
If the STL transmitter’s pre-emphasis cannot be defeated, then configure the 8200ST
for flat output. In this case, average modulation levels of the STL may have to be re-
duced to accommodate the overshoots. These issues are extensively discussed start-
ing on page 1-8.
1. Configure the 8200ST’s internal jumpers.
A) Remove all screws holding the 8200ST’s cover in place; then lift it off.
Refer to Figure 2-3 on page 2-12.
B) Place jumper JA in the C
LIPPER
O
N
position.
C) If you have defeated the STL transmitter’s pre-emphasis, place jumpers JE and
JF in the
P
RE
-E
MPHASIZED
position.
D) If you cannot defeat the STL transmitter’s pre-emphasis, place jumpers JE and
JF in the
F
LAT
position.
E) Replace the top cover, and then replace all screws snugly. (Be careful not to
strip the threads by fastening the screws too tightly.)
2. Install the 8200ST in the rack. Connect the 8200ST’s audio input and out-
put.
Refer to the 8200ST Operating Manual if you require information about installa-
tion, audio input, and audio output connections to the 8200ST.
3. Set 8200ST Output Level with tone.
A) Press the TONE button on the 8200ST.
The TONE lamp should light and the modulation meters should indicate
“0.” If they do not, re-strap jumpers JB and JC to “peak.” (Refer to Figure
2-3 on page 2-12.)