Orban OPTIMOD-AM 9300, Operating Manual

Page: 86 / 242

2-40
INSTALLATION ORBAN MODEL 9300
If You Have Forgotten Your Passcode
You can reset factory defaults and wipe out security passcodes (in case you forgot
your
A
LL
A
CCESS passcode).
A) Remove power from the 9300.
B) While pressing both the
E
SCAPE
and
S
ETUP
buttons, restore power.
The Restore Defaults screen appears.
C) To gain access to the 9300, press the
E
RASE
A
LL
P
ASSCODES
soft button.
D) Reprogram passcodes as necessary; see To Create a Passcode on page 2-37.
The RESTORE DEFAULTS button (in the Restore Defaults screen) restores
all System Setup and Input/Output parameters to their factory default
settings. It also erases all passcodes. You should never need to use this
button in an existing installation, although it is a convenient way to
make the 9300 “factory fresh” if it is being installed in a different facility.
The RESTORE DEFAULTS button takes you to a screen that allows you to
keep or erase any user presets that exist in your unit.
Remote Control Interface Programming
[Skip this step if you do not wish to program the GPI (contact closure) remote con-
trol interface.]
1. Navigate to S
ETUP
> N
EXT
> N
ETWORK
& R
EMOTE
> R
EMOTE
I
NTERFACE
.
2. Program one or more remote control interfaces.
A) Navigate to the desired Remote Contact button (1 through 8) by repeatedly
pressing the
N
EXT button.
B) Hold down the button while turning the knob to select the desired function
for the interface.
Use either button below the appropriate graphics; both work the same.
A momentary pulse of voltage will switch most functions, except as not-
ed.

Preset Name : switches the named preset on the air. The control interface
can recall any factory or user preset.

Input : Analog : selects the analog inputs.

Input : Digital : selects the digital input and but does not apply deempha-
sis to it.

Input : J.17 : selects the digital input and applies J.17 deemphasis
to it.