Orban opticodec 7200, Handbook

Page: 64 / 90

64 E OPTICODEC
OPTICODEC 7400
System Setup
The SPID numbers entered here are also sent when a
connection is being established. This is necessary only
when operating on USA or Canadian networks.
The identification number input and allocation takes places
as described in “Local Numbers”.
Here the number of dialing attempts between 1 and 5 can
be selected.
This menu items serves for setting the desired time between
dialing attempts (between 10 and 60 seconds).
If an existing connection is interrupted not by the dialing
OPTICODEC, but by possible ISDN problems, then here
you can define the number of redialing attempts between
0 and 5.
Under certain conditions (e.g. private branch exchange
PBX), a number that prefixes the ISDN number for dial-up
via ISDN can be entered here. To make an outside call
from a telephone system, for instance, enter 0.
A preselection number can also be entered here. The
number max not exceed five digits.
Using the 'Min. length for PBX Prefix‘ menu option, define
the minimum number of digits an ISDN number must have
to allow this prefix to be set before the number.
If, for example, internal extension numbers have three
digits, a 4 should be entered here.
To continue to enable internal calls, PBX dialling codes for
ISDN numbers with less than four digits are ignored.
SPID Numbers
Dialing
Dialing Attempts
Dialing Delay
Redialing Attempts
PBX Prefix
Min. length for
PBX Prefix