Oracle SUN X4-8, Installation Manual

Page: 60 / 154

Modify IPv6 Network Settings From the Oracle ILOM CLI
4.
Test the IPv4 network configuration from Oracle ILOM using the Network Test
Tool (Ping).
For details, see “Test IPv4 or IPv6 Network Configuration From the Oracle ILOM
CLI” on page 65 .
Modify IPv6 Network Settings From the Oracle ILOM CLI
Use this procedure to modify the server's IPv6 network settings using the Oracle ILOM CLI.
To modify IPv4 network settings, see “Modify IPv4 Network Settings From the Oracle ILOM
CLI” on page 57 .
Note -
You can also change network settings using the BIOS Setup Utility. For instructions, see
the Sun Server X4-8 Service Manual .
1. Log in to the Oracle ILOM CLI. See:
■
“Log In to Oracle ILOM Using a Local Serial Connection” on page 55
■
“Log In to Oracle ILOM Using a Remote Ethernet Connection” on page 55
Note -
If you log in to Oracle ILOM using an Ethernet connection, your connection is
terminated after you modify the network settings. You must log back in using the new settings.
2.
Use the
cd
command to navigate to the
SP/network/ipv6
directory:
->
cd SP/network/ipv6
3. Type the
show
command to view the IPv6 network settings configured on the
device.
For example:
-> show
/SP/network/ipv6
Targets:
Properties:
state = enabled
autoconfig = stateless
dhcpv6_server_duid = (none)
link_local_ipaddress = 2001:db8:214:4fff:feca:5f7e/64
static_ipaddress = ::/128
60 Sun Server X4-8 Installation Guide • December 2015