Install a Power Supply
3.
Press the release latch to the left to open the ejector arm (panel 1).
4.
Slide the power supply out of the chassis (panel 2).
Caution -
There is no restraint mechanism on the power supply to prevent it from sliding
completely out of the chassis. Use care when removing the power supply to prevent it from
falling.
Caution -
Whenever you remove a power supply, you should replace it with another power
supply. Otherwise, the server might overheat due to improper airflow. If a new power supply is
not available, leave the failed power supply installed until it can be replaced.
5.
Install a new power supply.
“Install a Power Supply” on page 85
.
Related Information
■
“Locate a Faulty Power Supply” on page 83
■
“Install a Power Supply” on page 85
Install a Power Supply
1.
Remove a power supply.
Servicing Power Supplies
85
Summary of Contents for SPARC T7-1
