Oracle SPARC Enterprise M4000, Installation Manual

Page: 65 / 78

Appendix B Fault Isolation B-7
At least three lines of new output are delivered to the user with the
-V
option:
■
The first line is a summary of information you have seen before in the console
message but includes the timestamp, the UUID, and the Message-ID.
■
The second line is a declaration of the certainty of the diagnosis. In this case you
are 100 percent sure the failure is in the asic described. If the diagnosis might
involve multiple components you might see two lines here with 50 percent in each
(for example)
■
The ’FRU’ line declares the part which needs to be replaced to return the server to
a fully operational state.
■
The ’
rsrc
’ line describes which component was taken out of service as a result of
this fault.
B.2.4.2
fmdump -e
Command
To get information of the errors which caused this failure you can use the
-e
option,
as shown in the following example.
B.2.5 Using the
fmadm faulty
Command
The
fmadm faulty
command can be used by administrators and service personnel
to view and modify system configuration parameters that are maintained by the
Oracle Solaris Fault Manager. The
fmadm faulty
command is primarily used to
determine the status of a component involved in a fault, as shown in the following
example.
The PCI device is degraded and is associated with the same UUID as seen in the
preceding example. You might also see “faulted” states.
# fmdump -e
TIME CLASS
Nov 02 10:04:14.3008 ereport.io.fire.jbc.mb_per
# fmadm faulty
STATE RESOURCE / UUID
-------- -------------------------------------------------------------
degraded dev:////pci@1e,600000
0ee65618-2218-4997-c0dc-b5c410ed8ec2