Oracle SPARC Enterprise M4000, Installation Manual

Page: 17 / 78

2-1
C H A P T E R
2
Preparing to Install the Server
This chapter describes the items you are required to check, the environmental
requirements for installation, installation areas, and other related matters. It contains
the following sections:
■
Section 2.1, “Safety Precautions” on page 2-1
■
Section 2.2, “Before Installing the Server” on page 2-2
■
Section 2.3, “Tools and Equipment” on page 2-9
2.1 Safety Precautions
To protect both yourself and the equipment, observe the following precautions when
possible:
■
Observe the precautions, warnings, and notes on handling shown on the server.
■
Use an
electrostatic discharge
(ESD) jack or wrist or foot strap when possible.
■
Do not block any ventilation holes.
■
Do not install the server at a location exposed to direct sunlight or near a device
that may become hot.
■
Do not install the server at a location that has a lot of dust or that is exposed to
corrosive gases or air with a high salt concentration.
■
Do not install the server at a location exposed to frequent vibrations. Install the
system on a flat and level surface.
■
Use grounding wires of class 3 or higher. Sharing any grounding wire will lead to
a malfunction.
■
Do not place cables under the equipment or have cables stretched tight. Do not
disconnect a power cord to the server while its power is on.
■
Do not place anything on the server or perform any work directly above it.