Oracle EE200, External Safety And Compliance Manual

Page: 34 / 96

Safety Precautions
34 Sun Storage 6 Gb SAS PCIe HBA, External Safety and Compliance Guide • February 2015
Caution -
For product installed in California, USA: This product may contain a time-of-
day battery which may contain perchlorate where special handling may apply. See
http://
www.dtsc.ca.gov/hazardouswaste/perchlorate
.
Energy Storage Module Caution
Caution -
There is a danger of shock or equipment damage if energy storage modules are
mishandled or incorrectly replaced. When replacing the energy storage modules, use only
replacement modules that have been provided by Oracle, following the instructions provided in
the product service manual. Do not disassemble modules or attempt to recharge them outside
of the system. Do not dispose of the modules; instead, return them to Oracle in accordance with
Oracle procedures for the product.
System Unit Cover
You must remove the cover of your Oracle computer system unit to add cards, memory, or
internal storage devices. Be sure to replace the cover before powering on your computer system.
Caution -
Do not operate Oracle products without the cover in place. Failure to take this
precaution may result in personal injury and system damage.
Rack System Instructions
The following or similar rack-mount instructions are included with the installation instructions:
■
Elevated Operating Ambient
– If installed in a closed or multi-unit rack assembly, the
operating ambient temperature of the rack environment may be greater than room ambient.
Therefore, consideration should be given to installing the equipment in an environment
compatible with the maximum ambient temperature (Tma) specified by the manufacturer.
■
Reduced Air Flow – Installation of the equipment in a rack should be such that the amount
of air flow required for safe operation of the equipment is not compromised.
■
Mechanical Loading – Mounting of the equipment in the rack should be such that a
hazardous condition is not achieved due to uneven mechanical loading.
■
Circuit Overloading
– Consideration should be given to the connection of the equipment
to the supply circuit and the effect that overloading of the circuits might have on overcurrent
protection and supply wiring. Appropriate consideration of equipment nameplate ratings
should be used when addressing this concern.