1
2
3
4
5
Use clean hands when handling a respirator.
1
. Remove packaging and open the respirator and take hold of the head straps.
2
. Hold the respirator over your nose, mouth and chin, lightly secure on the face with
one hand on the outside, and with your free hand pull the two retaining straps over
your head. Do not touch the respirator on the inside.
3
. Pull the lower retaining strap under your ears and pull the upper retaining strap
over the back of your head.
4
. Press the nose clip onto your face with both index fingers.
Spectacle wearers: remove the spectacle to adjust the nose clip!
Pinching the nose clip using one hand may result in improper fit and less
effective respirator performance. Use two hands.
5
. Perform a User Seal Check prior to each wearing. To check the respirator-
to-face seal, place both hands completely over the respirator and exhale
sharply. Be careful not to disturb the position of the respirator. If air leaks
around nose, readjust the nosepiece as described in step 4.
If you CANNOT achieve a proper seal, DO NOT enter the contaminated
area. Report to your supervisor.
Fitting - and Removal Instructions
Removal Instructions
:
Spectacle wearers: remove glasses before removing the respirator.
Hold the retaining straps with both hands, pull over your head and remove the respirator from
your face. Remove the respirator without touching the respirator components. Wash and
clean your hands after removing the respirator. Dispose of used product in accordance with
applicable regulations
.
Single use only! Do not reuse!
Storage Conditions and Shelf Life (Details see last page)
Before use, store respirators in the original packaging away from
contaminated areas, dust, sunlight, extreme temperatures, excessive
moisture and damaging chemicals.
When stored in accordance with temperature and humidity conditions
specified below, the product may be used until the "use by" date
specified on packaging. Always inspect product and conduct a user
seal check before use as specified in the
User Instructions
.
If you
cannot achieve a proper seal, do not use the respirator
.
Time Use Limitation
If respirator becomes damaged, soiled or breathing becomes difficult
(e.g. saturated with breathing air humidity), leave the contaminated
area immediately and replace the respirator.
The respirator is intended for single use and cannot be reused
.
Acceptable Fit Test Protocols
Fit Test Protocol*
Qualitative Protocols Saccharin Acceptable with this product!
Bitrex TM Acceptable with this product!
Quantitative Protocols* Acceptable with this product!
*Refer to OSHA 1910.134.
