29
E
nglish
Replacing the Lamp
When the projector’s lamp usage reachees 2,000 hours, it dis-
plays the following warning message “Lamp may fail soon !
Replacement Suggested !” When you see this message, please
contact your local reseller or service center.
Make sure the projector has cooled down for at least 30 minutes
before replacing the lamp.
Warning:
Lamp
compartment is hot!
Allow it to cool down
before replacing lamp!
Lamp Replacing Procedure:
1.
Turn off the power to the lamp by pressing the power button.
2.
Allow the projector to cool down at least 30 minutes.
3
. Disconnect the power cord.
4.
Use a screwdriver to remove the screw at the bottom of
projector as indicated.
5.
Remove the cover.
6.
Unscrew the three screws of the lamp module then remove the
lamp module.
To replace the lamp module, reverse the previous steps.
Warning:
To
reduce the risk of
personal injury, avoid
dropping the lamp
module or touching
the lamp bulb. If
dropped, the bulb
may shatter and cause
injury.
1
2
3
Appendices
