opto engineering LTDVE4CH-20, Instruction Manual

Page: 16 / 69

15
LTDVE4CH-20 | INSTRUCTIONS MANUAL
Preferred DNS server 192.168.0.2
Alternate DNS server 192.168.0.2
Modbus address 32
Modbus/TCP port 502
Modbus/UDP port 502
Table 12: default parameters for Ethernet communication
The IP address, subnet mask and DHCP use flag are some of the controller parameters and can be
changed using any of the available interfaces. The factory configuration uses the static IP address
192.168.0.32. The factory settings can be restored using the INIT button (see
chapter 11 for a
description of the INIT button functionalities).
10. Visual indicators
There are sixteen LEDs on the top panel of the controller and two LEDs embedded in the Ethernet
RJ45 jack. Some of them are used to show that power supplies are available, others are pulsed
when inputs and output are activated, while others are used to indicate activity on the communication
interfaces or fault conditions.
The exact meaning of each of the LEDs is listed in Table 13: meaning of the LEDs . The LEDs of the
top panel of the controller are identified by a unique label printed next to them. The Ethernet ACT
and LINK LEDs are identified by their position relative to the Ethernet RJ45 jack. The ACT LED is at
the left of the jack, while the LINK LED is at the right.
Number Name Colour Description
1 PWR Green Stable when logic supply is present
2 RUN Green Blinks periodically during normal operation
3 ERR Red Stable when power supply missing, blinks in error conditions
4 LD1 Yellow Pulses when light output 1 is activated
5 LD2 Yellow Pulses when light output 2 is activated
6 LD3 Yellow Pulses when light output 3 is activated
7 LD4 Yellow Pulses when light output 4 is activated
8 TR1 Green Pulses when synchronization input 1 is activated
9 TR2 Green Pulses when synchronization input 2 is activated
10 TR3 Green Pulses when synchronization input 3 is activated
11 TR4 Green Pulses when synchronization input 4 is activated
12 SH1 Yellow Pulses when synchronization output 1 is activated
13 SH2 Yellow Pulses when synchronization output 2 is activated
14 SH3 Yellow Pulses when synchronization output 3 is activated
15 SH4 Yellow Pulses when synchronization output 4 is activated
16 485 Yellow Blinks when there is activity on the serial interface
17 ACT Yellow Blinks during Ethernet data transmission
18 LINK Green Stable when Ethernet connection established
Table 13: meaning of the LEDs