21
SCAN NO. : 001
SET LEFT LIMIT
SET RIGHT LIMIT
SCAN SPEED: 161
RUN
STOP
BACK
EXIT
presets. Once you want to modify a preset, you can input the preset number you want to
modify and then follow the above steps to set the preset. You can successfully modify a
preset content.
CALL: Here is to recall preset. Move the cursor to PRESET NO and then input
corresponding preset value. Then move the cursor to CALL and then click confirm button to
go to a preset.
BACK: Go back to previous menu.
EXIT: Log out system menu.
For PELCO protocol user, please refer to the following special functions:
Call preset:
Call preset 28 or preset 95 to go to dome menu. Call preset 29 or preset 99 to
go to scan. Call preset 24 or preset 81 to go to pattern. Call preset 25 or preset 82 to go to
cruise (tour). Call preset 30 or preset 96 to stop scan or pattern. Call preset 31 or preset 83
to begin rotation. Call preset 33 to enable PTZ 180 degrees rotation. Call preset 34 to set
dome position as 0.
Set preset:
Set preset 26 or 92 to set scan left limit. Set preset 27 or 93 to set scan right
limit. Set preset 22 or 79 to begin record. Set preset 23 or 80 to stop record.
4.2.4.2
Pan
Move the cursor to PAN button and then click confirm button to go to setup interface.
PAN SPEED: Set dome rotation speed. The Value ranges from 1 to 255. Please use the
left/right button on the keyboard or in the speed dome terminal menu to set.
RUN: Move the cursor to call item and then click confirm button. The dome begins 360
degrees continuous rotation.
STOP: Highlight stop item and then click confirm button. The dome stops rotation.
BACK: Go back to previous menu.
EXIT: Log out system menu.
4.2.4.3
Scan
Move the cursor to SCAN button and then click confirm button.
SCAN NO: Here is to set auto scan number. The value ranges from 1 to 5. Please use the
left/right button on the keyboard or in the speed dome terminal menu to set.
SET LEFT LIMIT: Here is to set camera left address. Click confirm button to save current
setup.
PAN SPEED
：
181
RUN
STOP
BACK
EXIT
