OPTIMUM
M A S C H I N E N - G E R M A N Y
Safety
Version 1.0.1 2014-05-16
Page 83
Original operating instructions
TU2506 | TU2506V | TU2807 | TU2807V
GB
1
Safety
Glossary of symbols
This part of the operating instructions
explains the meaning and use of the warning notices included in these operating instruc-
tions,
defines the intended use of the lathe,
points out the dangers that might arise for you or others if these instructions are not
observed,
informs you about how to avoid dangers.
In addition to these operation instructions, please observe
the applicable laws and regulations,
the legal regulations for accident prevention,
the prohibition, warning and mandatory signs as well as the
warning notes on the lathe.
European standards must be kept during installation, operation, maintenance and repair of the
lathe.
If European standards are not applied at the national legislation of the country of destination,
the specific applicable regulations of each country are to be observed.
If necessary, the required measures must be taken to comply with the specific regulations of
each country before the lathe is used for the first time.
Always keep this documentation close to the lathe.
INFORMATION
If you are unable to solve a problem using these operating instructions, please contact us for
advice:
Optimum Maschinen Germany GmbH
Dr. Robert-Pfleger-Str. 26
D- 96103 Hallstadt
Email: [email protected]
gives further advice
calls on you to act
enumerations
