OPTIMUM
M A S C H I N E N - G E R M A N Y
Maintenance
Version 1.0.1 2014-05-16
Page 145
Original operating instructions
TU2506 | TU2506V | TU2807 | TU2807V
GB
4
Maintenance
In this chapter you will find important information about
Inspection
Maintenance
Repair
of the lathe.
ATTENTION !
Properly performed regular maintenance is an essential prerequisite for
operational safety,
failure-free operation,
long durability of the lathe and
the quality of the products which you manufacture.
Installations and equipment from other manufacturers must also be in good order and condition.
ENVIRONMENTAL PROTECTION
During work on the spindle head please make sure that
collector vessels are used with sufficient capacity for the amount of liquid to be col-
lected.
liquids and oils should not be split on the ground.
Clean up any spilt liquid or oils immediately using proper oil-absorption methods and dispose of
them in accordance with current legal requirements on the environment.
Collect leakages
Do not re-introduce liquids split outside the system during repair or as a result of leakage from
the reserve tank:collect them in a collecting container to be disposed of.
Disposal
Never dump oil or other substances which are harmful for the environment in water inlets, rivers
or channels.
Used oils must be delivered to a collection centre. Consult your supervisor if you do not know
where the collection centre is.
4.1
Safety
WARNING!
The consequences of incorrect maintenance and repair work may include:
Very serious injury to personnel working on the lathe,
Damage to the lathe.
Only qualified personnel should carry out maintenance and repair work on the lathe.
4.1.1 Preparation
WARNING!
Only carry out work on the lathe, if it has been disconnected of the power supply.
"Disconnecting and securing the lathe“ on page 93
Attach a warning label to the restarting by third parties.
