OPTIMUM
M A S C H I N E N - G E R M A N Y
Appendix
03 / 08 / 2006
Page 56
Ball bearing spindle assembly and maintenance instruction ; Version 1.4.7
©
2006
D
7
Appendix
7.1
Copyright
©
2006
This document is copyright. All derived rights are also reserved, especially those for translation,
re-impression, use of figures, broadcast, reproduction by photo-mechanical or similar means
and recording in data processing systems, whether partial or total.
The company reserves the right to make technical alterations without prior notice.
7.2
Warranty
Within the term of warranty, the company Optimum warrants for a perfect quality of its products
and will reimburse any cost for overhaul or exchange of defective parts in case of construction
error, fault in material and/or defect of fabrication.
The term of warranty for commercial use is 6 months and for use as an amateur it is 24 months.
Condition for a warranty claim due to construction errors, faults in material and/or defects of
fabrication is:
Proof of purchase and that the instructions for use had been followed.
In order to assert the claim of warranty, you have to present a typescript original receipt of
purchase. It must comprise the complete address, date of purchase and type designation of
the product.
The instruction for use the corresponding device as well as the safety information are to be
observed. Damages due to operator‘s mistakes may not be accepted as warranty claims.
Correct use of the devices.
The products of the company Optimum had been designed and built for certain purposes.
They are listed in the operating manual. The warranty claim may not be accepted if the ope-
rating manual is not being followed properly or if it is used for a purpose which has not been
intended or with improper accessory.
Maintenance work and cleaning.
It is absolutely necessary to maintain and clean the machine in regular intervals according to
the prescriptions of the instruction for use.
By intervention of a third party, any warranty claim will expire. Maintenance work and cle-
aning are usually not part of the claim of warranty.
Original spare parts.
Make sure to use only original spare parts and original accessory. This can be acquired from
authorized distributors of the machine. When other than original spare parts are being used,
consequential damages may occur and danger of accidents will increase. Disassembled or
partially disassembled devices and devices which are repaired with foreign parts are exclu-
ded from warranty claims.
Wearing parts.
Certain components are subject to wear out by time respectively a standard wear by use on
the corresponding machine.
Among these components are e.g. V-belts, ball bearings, switches, main cables, gaskets and
washers, etc. These wearing parts are not part of the warranty.
