Installation of step motors
OPTIMUM
M A S C H I N E N - G E R M A N Y
3 / 08 / 2006
Page 20
Installation of step motors Adapter kit BF20 Vario; BF20L Vario ; Version 1.4.7
©
20
06
GB
INFORMATION !
The shielding will be conntected to the terminal block of the engine on one side.
4.1.5
The cables will be peeled off at a length of about 5 mm with insulation stripping tongs.
4.1.6
Plug and press wire terminations on the ends of the cable.
4.1.7
Plug the strain relief over the cable.
4.1.8
Insert the cable through the opening of
the cover plate of the step engine.
4.1.9
Connect the cable to the engine and
tighten the strain relief.
4.1.10
The twisted screening goes with the
clamping "GND" .
Fig.4-4: Terminal block of the engine
4.1.11
Fasten the lid of the step engine with
the cross slot screwdriver.
4.1.12
Then cut the cable to the length which
is required to connect it to the CNC
controller.
Fig.4-5: Screw the lid
4.1.13
Connect the cable to the CNC controller as required.
Fig.4-6: Strip terminal CNC Controller VI
INFORMATION !
Do not connect a screening nor an earthing cable to the CNC Controller.
terminal block engine
screening
lid step engine
strip terminal
CNC Controller
Motor
Controller
A-
to
A-
A+
to
A+
B-
to
B-
B+
to
B+
GND
