ASE-C-MSA
User’s Manual
Page 6 of 10
Optilab, LLC
600 E. Camelback Road, Phoenix, AZ 85012
Phone: (602) 343-1496, Fax: (602) 343-1489, Email: [email protected]
4. Connect the power adapter to a PC for remote control by using an USB
cable or RS-232 cable.
5. After checking all physical patch cord connections, turn on the +5 V power
supplier, the electrical power is applied to the power adapter, the LED
indicator on the power adapter turns green.
6. Press the power switch on the power adapter to enable the electrical power
driving of the ASE module. Now the ASE module is ON, and the laser
current can be adjusted using the PC.
Turn-off Procedure
1. Set the pump current to be zero to turn off the laser.
2. Exit and close the command setting window of the module.
3. Press the power switch on the power adaptor to turn off the electrical power
applied on the ASE module.
4. Turn off the +5V power supply.
2.6
PC Connection Mode
For the standard ASE-C-MSA, connecting the ASE module to an external PC
will allow for parameter monitoring and pump current adjustments. If you have
an ASE-C-MSA with additional software control, please refer to the additional
supplemental manual for complete information.
Using the USB port (or RS-232 cable) on the cable assembly, connect the ASE
module to a PC using the following connection diagram and serial port settings: