ASE-C-MSA
User’s Manual
Page 2 of 10
Optilab, LLC
600 E. Camelback Road, Phoenix, AZ 85012
Phone: (602) 343-1496, Fax: (602) 343-1489, Email: [email protected]
2.
Operation
2.1
Introduction
This chapter describes how to operate the
ASE-C-MSA
unit and introduce the
location and function of the controls and connectors.
2.2
Initial Inspection
Your
ASE-C-MSA
was carefully inspected before it left the manufacturer. It
should be in proper working order upon receipt. You should, however, inspect
the unit for any damage that may have occurred in transit. If the shipping
container or the packing material is damaged, keep it until the contents of the
shipment have been checked to be free of mechanical and electrical damages.
Notify Optilab, LLC promptly if any notable damage is found.
2.3
Panel Diagram and Controls
F
EATURE
F
UNCTION
E
LECTRICAL
C
ONNECTION
P
ORT
,
30
PIN
This port is used to connect the ASE module to the Power
Adaptor. It is a 30-pin type connector, with the full pin-out
diagram is shown in section 2.4 of this manual
M
ODEL AND
S
ERIAL
N
UMBER
L
ABEL
This label shows the model number and serial number of
the device.
O
PTICAL
O
UTPUT
F
IBER
P
ORTS
The optical output fiber ports for the ASE module. The fiber
ports shown are FC/APC type.
1
3
ASE-C-MSA
1
2