OPTICOM SVD-2404A, User Manual

Page: 34 / 137

Camera Management DVR User Manual
26
4 Camera Management
4.1 Camera Signal
Click Start
→
Settings
→
Camera
→
Manage Camera
→
Camera Signal to go to the interface as
shown below.
Some models may support analog signal switching to IP signal, which means decreasing (or
increasing) the number of analog channels, accordingly increasing (or decreasing) the number of
IP channels.
The DVR device supports hybrid access of TVI, AHD, CVI and CVBS high definition cameras.
If the TVI high definition camera is accessed to the DVR, you should select TVI in the following
interface to show the camera image normally; if you select AHD, then there will be no image or
the image has no color. The default selection of the camera signal is Auto. If you select Auto, the
image of the camera will be shown normally regardless of the camera type.
Note:
You can enable “Lite” in the interface if the DVR supports “Lite” recording. It will lower
the recording resolution and increase the recording frame rate. Please enable or disable the Lite
as needed.
4.2 Add/Edit Camera
4.2.1 Add Camera
The network of the DVR should be set before adding IP camera (see 11.1.1 TCP/IP
Configuration for details).
Refer to the pictures below. Click Add Camera in the setup panel or in the top right corner
of the preview window to pop up the “Add Camera” window as shown below. You can quickly
add or add the IP camera manually.