ENGLISH
FRANÇAIS
DEUTSCH
IT
ALIANO
ESP
AÑOL
PORTUGUÊS
EN-4
ex) AX-70TN : 20 m (70 ft.)
0.7 - 1 m (2.3 – 3.3 ft.)
180° (±90°)
Transmitter
Receiver
10° (±5°)
Horizontally
Vertically
about 60 cm (2.0 ft.)
Detection range and installation
Alignment angle
Pole mounting
1
Detach the cover and the screw
2
Fix the mounting plate
3
INSTALLATION
3-1
NOTE
3-2
INSTALLATION METHOD
Distances between the Receiver and the
Transmitter
Pole size should be ø32 – 48 mm (1 1/4”-1 7/8”.)
(Standard U.S. 1 1/4” or 1 1/2” pipe)
Non-recommended installation angle
In case to be installed in these angles as below,
maximum detection range shall be half of the original
detection range. (The attenuation of beam by the
edge of the cover)
about 1 m
(3.3 ft.)
When removing the cover, do not put your
fingers on the hood, which may cause
damage.
1) Loosen the cover lock screw to detach
the cover.
2) Turn the optical unit and open the
waterproof plug.
3) Loosen the unit base lock screw and
slide the mounting plate downward to
detach the unit base.
Note>>
Cover Lock Screw
Hood
Optical Unit
Waterproof Plug
Unit Base lock Screw
Wall Mounting Screws
Mounting Plate
Wall mounting
Pole mounting (1 plate)
Pole mounting (2 plate)
Pole Lock Screws
Mounting Plate
Lock Screws
