Opitec MANITOU 101.200, Manual

Page: 22 / 28

101.200
21
4,5 V
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
30
70
Fork lift truck “MANITOU”
Electrics
Part No: 45-51b
1. Mount the battery under the bodywork using the remaining double sided sticky pad
2 Insert a piece of cable in the joiner block 3 and 4. Solder or crimp a connector on the ends and join to the
battery
3 Wire up the components according to the diagram
4. Hand steering set
Mark out and drill the holes in the polstyrol sheet ( Part Nr:47 ) for the switches 7,5mmdia and file out the
long shaped hole (Pattern A , page 22 ).
Finally bend the U shaped form. Use a hot air gun or strip heater ( Attention !! N.B. be careful of burns )
Glue the switches with super glue ( Be careful not to get glue in the switch )
Fit the connector block with two self tapping screws ( Part 46) see plan ( See page 22 )
View from underneath
View from underneath
Broken line represents the red wire = Plus pole
Continuous line represents the black wire + Minus pole
5. Connect the hand control, with the flat band cable to the
model. Connect the numbers from the hand control to the
corresponding numbers on the chassis connector.