Opex DS2200, User Manual

Page: 87 / 90

Statistics 87
DS 2200 User Manual - OPEX Corporation use only - not for distribution
ScanLink Plug-in Failed
Results when there is a failure sending
information to the ScanLink plug-in.
ScanLink Plug-in
Requested a Jam Results when the ScanLink Plug-in has
requested a jam.
Host to Controller Report
Missing
Results when the controller is expecting piece
information from the host and does not receive it
within the expected time window. This is
frequently caused by pushing the system to its
limits or by something causing the system to get
out of sync.
Jam Caused by Reject
Results whenever a reject other than Jamsorts
occurs. Thus every reject other than Jamsorts is
counted as a jam under this category. The Job
Parameter "Stop Machines for Rejects" must be
set to something other than "No" for rejects to
jam the machine. Otherwise, rejects will be
directed to the reject bin and processing will
continue.
Double Detected
The Multifeed Sensor indicates that two pieces
are being fed together.
MFD Skew Angle
Exceeded Sensor
Blocked
The MFD Skew Angle Exceeded Sensor is
blocked.
MFD Skew Damage
Exceeded Sensor
Blocked
The MFD Skew Damage Exceeded Sensor is
blocked.
Out Of Bounds Sensor
Blocked
The Out Of Bounds Sensor is blocked.
Out of Bounds Detected A piece is too tall for the imager.
Justification Sensor
Blocked
The Justification Sensor is blocked.
Feed Singulation Defeat
Button Stuck The override feed control button is stuck in a
down position.
Table 6: Reasons for jams (continued)