-12-
Wireless alarm
Ondico AB will start to sell different wireless alarm units which communicate with
Ontech 9030. Up to 7 different alarm detectors can be connected. The wireless alarm
detectors planned are A. Motion detector, B. Magnet switch/Alarm box and C.
Emergency Alarm button. Also a remote control to turn on/off the alarm will be offered.
Temperature alarm
The temperature alarm is trigged if the temperature rises above or drops below the
preset alarm temperature. See page 17.
Battery alarm
The unit alarms if the backup battery needs to be charged or if it is empty.
Wired alarm
Connect an alarm detector
When an alarm detector is activated it will either close or open an electric circuit. It can
be a magnetic switch detector, a level detector, a motion detector or any other kind of
sensor..
The jacket on the under side has the following markings:
G
Ground
A
Alarm input A
B
Alarm input B
12
Voltage 12 V
The connection cable has a connector in one end that fits in the jacket
Switch from Normally Open to Normally Closed mode
Locate the DIP-switch, see Fig 1.
Factory default for switch 1 is OFF. This mean the alarm inputs are set to NO mode. The
unit sends an ALARM A if connectors ”A” and ”+12” are connected and ALARM B if
connectors “B” and “+12” are connected.
If DIP switch 1 is set to ON the mode is switched to NC. The unit sends ALARM A if
connectors ”A” and ”+12” are disconnected and ALARM B if connectors “B” and “+12” are
disconnected.
