-19-
Thermostat function
If an electrical radiator is connected to the relay the unit can be used as a remote
thermostat controller.
By programming the desired temperature the unit will scan the temperature and
activate the relay (and thus turn on the radiator) if the temperature drops one degree C
below the set temperature. The surrounding air will be warmer and when the
temperature rises one degree C above the set temperature it will deactivate the relay
(turning off the radiator).
First connect the radiator to the relay.
Activate the thermostat from a telephone
1.
Call up the unit. Be sure you use tone mode on the telephone.
2.
The unit answers with a beep.
3.
Press your PINCODE and then #.
Example:
1234#
If the PINCODE is correct the unit replies with a beep. If it is not correct the call
is disconnected. Call again and try.
4.
Dial
2*D#
where D=the desired temperature. The unit confirms with a short
beep. Hang up. If the unit replies with two beeps, try again.
Deactivate the thermostat from a telephone
1.
Call up the unit. Be sure you use tone mode on the telephone.
2.
The unit answers with a beep.
3.
Press your PINCODE and then #.
Example:
1234#
If the PINCODE is correct the unit replies with a beep. If it is not correct the call
is disconnected. Call again and try.
4.
Dial
2#.
The unit confirms with a short beep. Hang up. If the unit replies with
two beeps, try again.
Activate the thermostat with SMS
1.
Activate the thermostat function by sending an SMS with the following
content:
ABCD#2*D#
where ABCD is your personal PINCODE. D is the desired
temperature.
