12
Getting Started
Installing OnStream Echo for your Workstation
If you installed your OnStream Digital Tape Drive on a workstation, all you have
to do is install the OnStream Echo software.
To install the OnStream Echo software, follow these steps:
1.
Turn ON your computer and allow it to boot.
2.
When your computer starts, Windows may detect that new hardware, your
OnStream Digital Tape Drive, has been installed. If this happens, you will see a
dialog box like the one shown below. Press Cancel and continue to the next
step.
Figure 11: Windows New Hardware Found dialog box: Press Cancel
OnStream Echo installs the driver for your OnStream Digital Tape Drive later.
3.
Insert the OnStream Installation CD-ROM into your CD drive. The OnStream
CD Setup program starts automatically.
Note: If the OnStream CD Setup program does not start automatically, click
the Start button on your Windows Taskbar, click Run, type d:\setup.exe,
replacing d: with the letter assigned to your CD-ROM drive, and click OK.
4.
When the OnStream CD Setup program prompts you to select your drive type,
click the SC30 or SC50 radio button.
5.
Press the Install OnStream Echo button.
6.
Follow all on-screen instructions.
7.
When installation is complete, restart your computer.
Press Cancel if
you see this
dialog box
SCSIGSGuide.book Page 12 Tuesday, January 19, 1999 1:02 PM
