12
Connecting antennas
1. Press down the lever.
2. Insert the wire into the hole.
3. Release the lever to replace it.
Assemble the loop antenna as shown in the illustration. (Refer to
the next page for details on connecting the AM loop antenna.)
Connecting the T-shaped antenna or 300 ohm ribbon wire to
the 75/300 ohm antenna adapter:
Loosen the screws and wrap the wires around them. Then, tighten
the screws with a screwdriver.
Connecting the coaxial cable to the 75/300 ohm antenna
adapter:
1. With your fingernail or a small screwdriver, pull the stoppers
outward and remove the cover.
2. Remove the transformer wire A from slit B and insert it into slit
C.
3. Prepare the coaxial cable as shown in the diagram. Connect the
coaxial cable to the 75/300 ohm antenna adapter.
1
Insert the end of the cable.
2
Clamp it in place with pliers.
4. Re-install the cover.
Do not use the same antenna for both FM and TV (or VCR) recep-
tion since the FM and TV (or VCR) signals can interfere with each
other. If you must use a common FM/TV (or VCR) antenna, use a
directional linkage type splitter.
Antenna cables
AM loop antenna
75/300 ohm antenna adapter
(worldwide and some other models)
Directional linkage
1
2
3
Insert into the slot.
Outdoor
FM/TV
antenna
Indoor
T-shaped
antenna
300 ohm
ribbon wire
✦ ✦
✦
✦ ✦
✦
✦
✦
✦
✦
✦
6
mm
3
mm
6
mm
15mm
2
1
Slit C
Slit B
Wire A
1
2
3
Directional linkage
type splitter
To TX-SV373/TX-SE350
To TV (or VCR)
