61
En
You’ll need to enter a code for each component that you
want to control.
Note
• The remote control codes provided are correct at the time of
printing, but are subject to change.
Onkyo components that are connected via
u
are con-
trolled by pointing the remote controller at the AV
receiver, not the component. This allows you to control
components that are out of view, in a rack, for example.
If you want to control an Onkyo component by pointing
the remote controller directly at it, or you want to control
an Onkyo component that’s not connected via
u
, use the
following remote control codes:
•
BD/DVD
`
30627
:
Onkyo DVD player without
u
•
TV/CD
`
71817
:
Onkyo CD player without
u
`
11807
:
Onkyo TV
If you want to control an Onkyo component by pointing the
remote controller directly at it, use the following remote
control codes:
`
32900
:
Onkyo Blu-ray Disc player
`
32901
:
Onkyo HD-DVD player
`
70868
:
Onkyo MD recorder
`
71323
:
Onkyo CD recorder
`
82990
:
Onkyo Dock
Note
• If you connect a cassette tape deck to the
TV/CD
IN
jack, or
connect an RI Dock to the to the
TV/CD
IN
or
VCR/DVR IN
or
GAME IN
jacks, for
u
to work properly, you must set the Input
Display accordingly (
➔
27
).
Entering Remote Control Codes
1
Look up the appropriate remote control code in
the separate Remote Control Codes list.
The codes are organized by category (e.g., DVD
player, TV, etc.).
2
While holding down
REMOTE MODE
to which
you want to enter a code, press and hold down
DISPLAY
(about 3 seconds).
The remote indicator lights.
Note
• Remote control codes cannot be entered for
RECEIVER
and
ZONE 2
.
• Only TV remote control codes can be entered for
TV
.
• Except for
RECEIVER
,
TV
and
ZONE 2
, remote control
codes from any category can be entered as
REMOTE
MODE
. However, these buttons also work as input selec-
tor buttons (
➔
25
), so choose a
REMOTE MODE
that
corresponds with the input to which you connect your
component. For example, if you connect your CD player
to the CD input, choose
TV/CD
when entering its remote
control code.
3
Within 30 seconds, use the number buttons to
enter the 5-digit remote control code.
The remote indicator flashes twice.
If the remote control code is not entered success-
fully, the remote indicator will flash once slowly.
Remote Control Codes for Onkyo
Components Connected via
u
1
Make sure the Onkyo component is connected
with an
u
cable and an analog audio cable
(RCA).
See “Connecting Onkyo
u
Components” for
details (
➔
21
).
2
Enter the appropriate remote control code for
REMOTE MODE
.
•
BD/DVD
`
31612
:
Onkyo DVD player with
u
•
TV/CD
`
71327
:
Onkyo CD player with
u
`
42157
:
Onkyo cassette tape deck with
u
•
PORT
`
81993
:
Onkyo Dock
See the previous section for how to enter remote
control codes.
Note
• When using a cassette tape deck connected via
u
, press
and hold
TV/CD
to switch to TAPE.
3
Press
REMOTE MODE
, point the remote control-
ler at the AV receiver, and operate the component.
