DV-CP701
UPGRADE THE FIRMWARE/ TEST MODES
6-2
It's display "COMPLETE" on FL tube after initializing for setting and mechanism setting.
The unit will be going to "STANDBY" after display "COMPLETE".
NOTE: All of the setting (VIDEO, AUDIO & etc.) will be initialized.
Please refer the "Default Setting" for each destination.
6 Initialization
6-1
Press the "STOP" & "STANDBY" at the same on the DV-CP701 with NO DISC condition.
5 The method of set the REGION CODE with special remote controller. (RC-484M)
5-1
Press the "STOP" key and "DISPLAY" key at the same time with NO DISC condition.
Press "DISPLAY" key to indicate the "REGION" code on the monitor.
5-2
Press "DVD" and "2" key at same time and press "RETURN" key with NO DISC condition.
Then "REGION SET" is displayed on the FL tube.
MDD1N
5-3
Press "1" key.
"REGION 1" is displayed on the FL tube.
MPA4P
5-4
Press "4" key.
"REGION 4" is displayed on the FL tube.
5-5
Press "STANDBY" key of the DV-CP701 to exit the REGION setting mode.
Remove the solder of Laser Diode shorting
Connect the FFC to PWB (NADG-7807) and Pickup.
Remove the solder of short-circuit land (2-points) for the laser diode destruction
prevention with the soldering iron.
Setting the regional code
REMOTE CONTROLLER for
UPGRADE
Part No. 24140484 (RC-484M)
