1 Updating the Firm Ware
1-1
Open the DISC tray and set the Firm Ware Recorded DISC on DISC1 bay.
1-2
Close the DISC tray.
Will start the Firm Ware updating automatically.
Will tray open after finish the updating.
1-3
Take out the disc.
2 Test mode
2-1
Press the "STOP" & "DISPLAY" at the same with NO DISC condition.
Current version number of sub-micon is displayed on the FL tube.
2-2
Press the "DISPLAY".
Current microprocessor version number of BACK END displayed on the FL tube.
The REGION code will display on the monitor display.
MDD1N : REGION code 1
MPA4P : REGION code 4
2-3
Press the "DISPLAY".
Current microprocessor version number of FRONT END is displayed on the FL tube.
2-4
Press the "DISPLAY".
All segment of FL tube light up.
2-2
Press the "DISPLAY".
Will be displayed "DISPLAY KEY" on FL tube.
2-6
Press any keys except "STANDBY".
The function name of pressed key is display on the FL tube.
Press each key and confirm that the name of pressed key.
2-7
Press "STANDBY" to exit the test mode.
3 Dimmer control
Press "DIMMER" key and confirm the Dimmer control.
Even press the "DIMMER" key, Luminance of FL tube change as follows.
FL tube
:
Bright
Dark1
Dark2
Dark2
Bright
Center light
:
ON
ON
ON
OFF
ON
4 Destination setting
R757
R758
Destination
Region Code
TV mode
MDD1N
OPEN
2.7K
North America
1
NTSC
MPA4P
0 ohm
OPEN
Australia
4
PAL / AUTO
DV-CP701
UPGRADE THE FIRMWARE/ TEST MODES
